Series E4.32AG - chain, openable from both sides with crossbars every link

Separators can be arranged in any position in the chain cross-section. As standard separators should be fitted every 2nd e-chain® link.

• NEW: Divisible separator T323(A) for use with shelf 386.X- ideal for retrofitting or for the initial equipping of the e-chain®. Fast assembly/disassembly possible using snap/slider mechanism. Saves installation time. Increases flexibility.
   
  
• Standard separator 281 for e-chains® offers secure stability under load with its wide base, even for large cables and hoses. If the distance between the separatorsmust be greater, separator 281.14 can be used
   
  
• Separator 283 with a narrow base for e-chains® for applications with many small cables that should be separated from each other.
   
  
• Separators can be fixed in place with the help of spacers 381.XX for e-chains®. The available inner height is reduced by 2mm for each spacer. To prevent this, parts can also be installed from the outside onto the opening crossbar (not on long travel applications). XX = Spacer width (choice of 10, 15 and 20mm).
   
  
• Locking separator 293 for e-chains® - with increased holding force for applications with very high humidity or extreme loads. The increased holding strength is produced by the asymmetric teeth locking into the crossbar. Please ensure even alignment.
   
  
• Asymmetrical separator 281A for e-chains® with 12 mm base, for the combination of spacers and separators with different widths, e.g. for side-mounted applications.
  

When many cables with different diameters are used - e-chains® and e-tubes can be divided vertically and horizontally.

• NEW: Divisible separator T323(A) for use with shelf 386.X- ideal for retrofitting or for the initial equipping of the e-chain®. Fast assembly/disassembly possible using snap/slider mechanism. Saves installation time. Increases flexibility.
   
  
• Side plates 286, middle plate 288 and shelves 386.X allow flexible partitioning Shelves of various widths can be arranged in steps of 7mm on 3 levels.
   
  
• For special applications: Separator with injection-moulded shelf 281.S.57 (57.5 mm) or 281.S.45 (45 mm)
   
  
• For a more divided solution height slot separators 291 can be used. However, these cannot be integrated into existing shelving without removingthe interior separation system
   
  
• The one-sided open height slot separator 297 can be retrofitted without dismantling the existing interior separation. When using the open height slot separators, the top and bottom slots cannot be used for shelves.

Strain reliefs

Strain reliefs